Filtration for Abrasives and Gas

Use the thirty foot (30’) one piece filter(s) with one joint of fiberglass or steel tubing attached to the bottom (bull plug on end of last joint of tubing).

Then install a gas anchor through the middle ( use 2 jts. solid, and 1/2 jt on bottom with the end plugged, with the last 1/2 joint perforated).

We would also like to see you set all of this approximately 30’ above your top set of perforations, if it will allow you to make the daily production you are now making.

Gas should not enter into the filter, but if it does it will not travel down to the perforations at the bottom of the gas anchor.